Careers at ALNADA Contracting

Design, installation, commissioning and maintenance of fire protection systems across Egypt.

No published vacancies at the moment. We would rather say so than advertise a role that is not open, and every CV that arrives goes on file, because that list is where we go first when one does.

Send your CV

Design and calculation

Hazard classification, hydraulic calculations, pump sizing and shop drawings, checked against NFPA, the Egyptian Fire Protection Code and Civil Defense before any material is ordered.

Fire pump set with pressure gauges and isolation valves
A pump set sized by calculation

Installation

Crews install to the design with as little disruption to operations as possible, and the engineers who drew it stay involved until the work matches it.

Smoke detector being installed into a suspended ceiling
Detection commissioned on site

Testing and handover

Flushing, hydrostatic, flow and churn, then acceptance testing. Documented, handed over, and tested before anybody calls it finished.

Portable fire extinguisher valve being checked during service
Pressure and valve checked, one unit at a time

Approval and maintenance

Civil Defense approval, then scheduled inspection, maintenance and emergency repair. This is the stage a CV here joins: work that reaches the code, and stays accountable after handover.

Portable fire extinguishers during scheduled servicing
Extinguishers during scheduled servicing

Send us your CV.

Attach it to either message below. A PDF, or a clear photo of one, is fine. Every CV that arrives goes on file, and that file is where we go first when a role opens.

Office hours are Sat-Thu: 9:00 AM-4:00 PM.

Useful in it: what you installed or maintained, the standards you worked to, and your certifications.